Home > Error Code > Error Code D1704

Error Code D1704


Verify that there is only one of each type of cassette installed in the dispensing mechanism. 2. Verify that the telephone line is operational. Check wiring connections to the CDU main board. Clear the error. http://ajdesignsoftware.com/error-code/error-code-start-process-failure-code-1603.php

Network denial code. If the error does not repeat again, complete a live dispense to verify the note diverter moves the currency to the exit position. If you wish to change this warning, please update your preferences through our website. Clear all errors and test the dispenser with a live transaction. http://www.propointcs.com/index.php/tranax/Page-11.html

Atm Error Code 3-da001

Error Code: 143 Description: PTDF error. Contact host processor. Refill the cassette as needed. 2. Error Code: 183 Description: Receipt paper low Recommended Action: Install a new roll of paper if needed.

Error Code: 302(32h)[2] Description: Empty Cassette. Recommended Action: This error code will occur only in cash dispensers running ACS terminal software. Paper of a lesser thickness is more prone to jamming. 20012 Receipt printer feed lever open Close the feed tray on the printer. Atm Error Code 3-da000(20) Verify that version of Mini-Bank Software matches host processor.

Reset the cash dispenser and clear the error. Contact host processor. Turn dispenser over by hand, and then reinitialize. Use an electrical parts contact cleaner on terminals.

C004D Cash cassette not properly set Reset the cassette, check position of microswitch on right rear wall of cassette bay in the dispenser. Atm Error Code F0001 Check the reject analysis to determine the cause of reject (reports menu). Set RMS Phone number – (Host Setup) F000F Terminal ID is not set. Contact host processor.

Atm Error Codes Hyosung

Verify modem function. http://repairpcfiles.com/error-code-d1704.php Error Code: 155 Description: Electronic journal modify record failure. Atm Error Code 3-da001 Recommended Action: Enter the management function and configure the terminal ID correctly. Atm Error Code 3-da000(80) Inspect the feed path for jammed currency.

Do several test dispense operations. http://ajdesignsoftware.com/error-code/error-code-8-wow.php CDN0F CDU connection failure Check cables between CDU and Mainboard, remove cables (even though they may be attached) and re-connect. If the error clears, put the cash dispenser back in service. D0052 No checking account. Atm Error Code D0111

Thanks for the info.” Your Name Your Email Comment Error Code D1704 The Pro an out, there’s theoretically get base levelopers worth the problems by none other tools Review by Recommended Action: This status occurs when a note arrives at the double detect without being seen by the feed sensor. 1. Error Code: 369 Description: Dispenser device reset. Source Inspect the feed path for jammed currency.

If the error clears, put the cash dispenser in service. 4. Triton Atm Error Codes When this is done, the terminal will operate normally until it is completely out of paper. You may also want to try the reset button on the printer to clear this error.

Error Code: 154 Description: Unknown electronic journal error code.

This can also be a problem with programming, check all programming (especially Dual Master Key setting and Host Processor Mode). Inspect the cassette detection microswitch. Clear the jammed documents. 2. Genmega Error Codes Purge the dispenser using the purge command from diagnostic menu. 2.

Verify that version of ATM Software matches host processor. D0055 Invalid PIN Code reported from host processor - Verify all programming. D2000 Phone line Busy Verify host phone number - call line with handset and check for busy signal - See D170x. have a peek here The reject vault should be emptied as soon as possible in order to avoid an "Out of Service" condition that occurs when the number of reject events reaches 50.

Retry the test operation and request fifty or fewer notes. If any sensor is out of its calibration limits, clean all of the sensors and attempt to do a transaction. One or two instances of this error does not usually indicate a defective part. D0300 Modem is not responding.

Clear all errors and test the dispenser by completing several TEST DISPENSES. Purge the dispenser using the purge command. 3. Install the cassette. Verify that version of ATM Software matches host processor.

If the error code returns, replace the note transport module. Contact your ISO or processor if you encounter an excessive amount of these errors, or you cannot complete a test transaction because of this error. Perform a live transaction. Phone line is in use or is being shared with another phone device (FAX, POS, phone) D1900 No answer.

Recommended Action: This error is usually associated with ""unfit"" currency or an empty cassette. 1. Clear any jammed currency. 2. D2100 Modem initialization error Check modem in diagnostics or modem test. Double detect module may require adjustment.

If no bills are present try using compressed air to clean the dispenser (a sensor may be blocked by dust). Please try the request again.